Security Perth Agility 3 Manual de usuario descargar pdf (Pagina 12)

Agility 3 User Manual

Page 12

Chapter 2 - Local System Operation

2.1 Arming your system

Arming your system causes the intrusion detectors to trigger an alarm when violated. The

arming operation will be followed by a local message announcement (if defined).

Before arming the system check the Ready LED and make sure that the system is ready

to be armed. If the system is NOT ready to be armed secure or bypass the violated zone(s),

and then proceed.

Failing to arm the system will be indicated by the system

Your Agility offers the following kinds of arming:

Note: If you are unable to arm the system, press the status key to view system messages.

Away (Full) arming:

Away arming prepares all of the system's intrusion detectors to activate an alarm if

violated, and is used when leaving the premises. The system will arm after the

designated countdown time (Exit delay) and a local message will sound. Once you have

armed the system, exit via the designated final exit door.

To arm using

Away (Full) arming procedure

Quick mode:

High security mode: Press + code

Quick mode:

High security mode: + code or proximity tag

Press

Send SMS : [Code][A], example, 1234A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Sin comentarios

Security Perth Agility 3 Manual de usuario Pagina 12